Tools Needed:

1. Heat Gun or Hair Dryer
2. Sharp Exacto for trimming and poking any bubbles (sewing needle also works well for poking holes)
3. Squeegie (if used apply tape over the edge of the squeegie keeping the squeegie from scratching the graphics)

Install Tips:

DO NOT use water or any other liquids it iwll cause problems with adhesions to the plastic

1. Thoroughly clean plastic of any debirs with rubbing alcohol, brake cleaner, or carb cleaner. Do not use windex or any cleaner that will leave a film on plastic. NEW PLASTIC must be cleaned very well becuase of the oils applied to plastic that gives it the shiny look.

2. Remove a small part of the backing and allign the holes of the graphic with the holes of the plastic and apply your piece of the graphics that has the adhesive exposed.

3. Remove the backing very slowly applying pressure with your hand or squeegie ti the front of the graphic. If the holes dont line slowly pull the graphic up and re-allign.

4. If decal wrinkles apply heat til the graphic is soft and push from the center out flattening the wrinkle.

5. Apply heat around graphic (especially the outside allowing adhesive to bond well to the plastic). If you have bubbles after you've heated the graphic poke the bubble with sharp exacto or sewing needle.

We recommend not riding or washing your bike for atleast 6 hours checking periodically for any lifting. If it does lift, heat area with heat gun.